shop-talk
[Top] [All Lists]

Re: [Shop-talk] New Garage

To: <shop-talk@autox.team.net>
Subject: Re: [Shop-talk] New Garage
From: "Kent Sullivan" <kentsu@corvairkid.com>
Date: Sat, 27 Jun 2009 22:46:56 -0700
Be careful with your decision about a crowned floor--this will make any type
of lift except one sunk into the pad pretty much not doable. While a little
bit of angle at the floor doesn't seem like much, it's a lot when a heavy
vehicle is 6 feet in the air.

--Kent
-----Original Message-----
From: shop-talk-bounces@autox.team.net
[mailto:shop-talk-bounces@autox.team.net] On Behalf Of eric@megageek.com
Sent: Thursday, June 25, 2009 10:40 AM
To: John Innis
Cc: shop-talk@autox.team.net
Subject: Re: [Shop-talk] New Garage

What I am doing is paving a pad that is 1 foot smaller in each dimension 
of the building.  That way, any snow or water on the vehicles will run to 
the sides and drop into the ground (the pavement is crowned.)

There is also a 65' X 12' driveway to the new building in that paving 
cost.

Moose
Everything I know about knots, I learned from Alexander the Great.



John Innis <jdinnis@gmail.com> 
06/25/2009 13:19

To
eric@megageek.com
cc
shop-talk@autox.team.net
Subject
Re: [Shop-talk] New Garage






So does this work when you are putting the building up on a paved pad?
 I have seen these put up before where they basically build the
building, then poured the floor, but not one built on an existing pad.
 Do they cut the pad to put in the posts, or do you have to put
anchors in the pad where the frame/posts are going to go?

On Thu, Jun 25, 2009 at 11:56 AM, <eric@megageek.com> wrote:
> I'm also paving the area first.
>
> The paving is just shy of $6K and the building I got for just shy of 
$10.
=================================
= Never offend people with style when you   =
= can offend with substance --- Sam Brown  =
=================================
You are subscribed as kentsu@corvairkid.com

Shop-talk mailing list

http://autox.team.net/mailman/listinfo/shop-talk

http://www.team.net/archive
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


Shop-talk mailing list

http://autox.team.net/mailman/listinfo/shop-talk

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>