shop-talk
[Top] [All Lists]

Re: Drilling 4" hole through concrete

To: Shop Talk <shop-talk@autox.team.net>
Subject: Re: Drilling 4" hole through concrete
From: Bill Rabel <brabel@dlux.net>
Date: Tue, 23 Dec 2003 13:45:13 -0800
I've drilled a fair number of holes through concrete, and the biggest 
obstacle is reinforcing steel. If your house dates from 1920, you might 
be able to find out what local practices were then, and if you're 
lucky, there's probably no rebar.

You could line drill the hole with a 1/2 or 3/4 inch carbide bit, or 
you may be able to rent a large rotohammer and a 4" carbide core bit. 
If you can't rent the bit, you may be able to rent the tool and buy a 
bit and the shank it screws onto. The carbide core bid doesn't need 
water, so it's only mildly dusty instead of really sloppy.

After you find out what all this will cost, you can then compare it 
with what it will cost to have a concrete-cutting contractor come in 
and do it for you. If they cut with diamond, it may or may not need 
water, but they're equipped to deal with it. The advantage of diamond 
bits is that they can cut through steel, too.

The most cost-effective is to drill the outline with a series of small 
holes, but this is also the most time-consuming.

- Bill Rabel
   Anacortes, WA





<Prev in Thread] Current Thread [Next in Thread>