shop-talk
[Top] [All Lists]

Re: shop heaters, more specific

To: ch155@freenet.buffalo.edu, shop-talk@autox.team.net
Subject: Re: shop heaters, more specific
From: Scott Whitehead <swhiteh3@mpdr0.detroit.mi.ameritech.net>
Date: Sun, 07 Nov 1999 18:39:04 -0500
But if it is propane, then it should give off some kinf od CO2/CO, and
that would concern me.  Am I wrong on this??  I assumed that anything
with any kind of combustion was out of the question.

Scott Whitehead
http://www.ameritech.net/users/swhiteh3/home.htm

Art Pfenninger wrote:
> 
> The type of heater that mounts on a 20 lb propane tank. Cheap to but and
> operate. Home Depot or Harbor Freight.
> ...Art
> 
> On Sun, 7 Nov 1999, Scott Whitehead wrote:
> 
> >
> >
> > > >I'm looking at the harbor freight catalog, they advertise 'glo-warm'
> > > >heaters.
> > <snip>
> >
> > Okay guys, sorry for jumping into the middle of a thread... but I have a
> > question.  I have a two car uninsulated garage, and I wanted to heat it
> > this winter.  It doesn't have to be 70 degrees, and I will only use it
> > when I am in there, not all the time.
> >
> > Is there anything I can use that requires NO venting or permanent
> > installation??  I thought there were some semi-reasonably priced
> > electric heaters that you could hang from the rafters....
> >
> > Again, this will only be only for short periods of time, so I don't mind
> > if it is expensive to run.  I just want the initial cost to be
> > reasonable, and it needs to be able to take the chill out of the air.
> >
> > By the way, I just ran dedicated 30 amp service to the garage, so I have
> > an electric line that can handle it.  I just hope the line can handle
> > the heater AND the compressor at the same time.  :-)
> >
> > Thanks for any info.  Specific models/sources/prices would certainly be
> > appreciated, as well as any first hand experience.  I won't be here
> > forever, so I am NOT willing to run any vents/pipes or stuff like that.
> >
> > Scott Whitehead
> > http://www.ameritech.net/users/swhiteh3/home.htm
> >

<Prev in Thread] Current Thread [Next in Thread>