When I purchased break cable dust cover from Mike Dowley some
12 years ago, Volkswagen boots came. Looks almost original and
it didn't melt like aother one!
Hiro
>
> From: TATERRY@aol.com
> Date: 2003/02/06 木 午前 08:27:50 GMT+09:00
> To: DSBonar@aol.com, mg-mmm@autox.team.net
> Subject: Re: dust boot replacements?
>
> In a message dated 2/5/03 14:48:12 Pacific Standard Time,
DSBonar@aol.com
> writes:
>
> << Anyone have a source for brake cable dust excluders?
>
> I have seached high and low for anything close to PA. I've
been to cycle
> shops (where I was way short on both leather clothing and
tatoos), auto
> parts
> shops (spark plug boots, emergency brake covers), lawn
equipment repair
> shops
> and boat supply shops.
>
> Anyone have a supplier? >>
> Harley Davidson part number 38630-88 Clutch Cable Boot, only
available if you
> have proper tatoo......
>
> CNC, Inc 1221 W. Morena Blvd. San Diego, CA 92110 part no.
1294 Boot for
> hydraulic throttle
>
> or VW311713269A cable boot for a Dasher fast back 311.....I
haven't actually
> seen this one. The Harley boot is a little longer and
bigger but easier to
> get on over the clevis.
>
> You'll need two per brake of the CNC to make a nice looking
job......
>
> And of course, Mike Dowley has these......
>
> Terry
>
> /// unsubscribe/change address requests to majordomo@autox.
team.net or try
> /// http://www.team.net/cgi-bin/majorcool
> /// http://www.team.net/mailman/listinfo
> /// Archives at http://www.team.net/archive/mg-mmm
> /// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|