land-speed
[Top] [All Lists]

Re: wheel back spacing?

To: "Albaugh, Neil" <albaugh_neil@ti.com>, "Keith Turk" <kturk@ala.net>,
Subject: Re: wheel back spacing?
From: "John Beckett" <landspeedracer@msn.com>
Date: Mon, 12 May 2003 18:19:42 -0400
Right Neil, when working on the front end you are changing the scrub radius
when you change the wheel spacing. Not necessarily a good thing to do when
turning corners.

JB

----- Original Message -----
From: Albaugh, Neil
Sent: Friday, May 09, 2003 6:54 PM
To: 'Keith Turk'; 'land-speed@autox.team.net'
Subject: RE: wheel back spacing?

Keith;

It depends on your "kingpin inclination". Fred Puhn's book discusses the
geometry of this-- if I remember correctly.

Regards, Neil     Tucson, AZ


-----Original Message-----
From: Keith Turk [mailto:kturk@ala.net]
Sent: Wednesday, May 07, 2003 8:33 AM
To: land-speed@autox.team.net
Subject: wheel back spacing?


I was just out futz'n in the shop...  y'all do this .. ya just call it
something else... like working or something...

Anywho...  I was looking at the back spacing on the Corvette... and the
wheel centers are way out on the outside of the wheel  ...

On the race car my wheel centers are located marginally on the outside of
the wheel by about 2" because I'd acquired 2 sets of Taylor made 18" wheels
with M/T Bville tires on them and that's the way they came...  So when Joe
and I planed the Quick change we simply made the width right with those
wheels...

For the real question... As we design our own cars... would there be a
stability advantage to placing the Wheel centers Way on the outside of the
wheel thereby giving the hub's a greater distance between them?

Or am I playing on the wrong side of the decimal point as Dave would say?

Keith

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/land-speed
///  what is needed.  It isn't that difficult, folks.


<Prev in Thread] Current Thread [Next in Thread>