healeys
[Top] [All Lists]

[Healeys] Shims in front hub

Subject: [Healeys] Shims in front hub
From: michael.salter at gmail.com (Michael Salter)
Date: Fri, 24 Aug 2018 20:08:16 -0400
References: <1407946030.167669818.1535148456495.JavaMail.zimbra@windstream.net>
Hi Tom, it's fairly simple.
You keep removing shims until the bearings tighten up when you snug up the
nut; then add shims about 0.002" at a time, until you reach a point where
the hub turns freely.
M

On Fri, Aug 24, 2018 at 7:09 PM Tom Felts <tomfelts at windstream.net> wrote:

> What's the procedure for determining how (size) shims to put in against
> the spacer?  Are they for end float?  If so, what is the procedure for
> measuring end float?
>
> tIA
> tom
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/michaelsalter at gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/healeys/attachments/20180824/d40dd176/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>