healeys
[Top] [All Lists]

[Healeys] Shims in front hub

Subject: [Healeys] Shims in front hub
From: rchaskell at earthlink.net (Bob Haskell)
Date: Fri, 24 Aug 2018 19:26:44 -0400
References: <1407946030.167669818.1535148456495.JavaMail.zimbra@windstream.net>
Tom,

The general process is to put in too many shims, measure the end float 
and subtract about that thickness of shims and repeat.  Don't install 
the seal in the hub until you've got the shims figured out.

I made a nut to replace the castellated nut, that extends out past the 
end of the hub.  Then use a dial indicator on a magnetic base attached 
to the brake rotor to measure the end float. Just push and pull on the 
splined hub to see what the total float is.

Image 0670 is the nut I made.  Image 667 is a mock-up on the bench of 
how it's used.

Cheers,

Bob Haskell
AHCA 3000 MkI registrar
http://www.ciahc.org/registry_3000mk1.php

On 08/24/2018 06:07 PM, Tom Felts wrote:
> What's the procedure for determining how (size) shims to put in against 
> the spacer?? Are they for end float?? If so, what is the procedure for 
> measuring end float?
> 
> tIA
> tom
> 
> 
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> 
> Archive: http://www.team.net/pipermail/healeys
> 
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
> 
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/rchaskell 
> at earthlink.net
> 
-------------- next part --------------
A non-text attachment was scrubbed...
Name: frt_wheel_brg_preload-0670.jpg
Type: image/jpeg
Size: 48595 bytes
Desc: not available
URL: 
<http://autox.team.net/pipermail/healeys/attachments/20180824/336bfd27/attachment.jpg>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: frt_wheel_brg_preload-0667.jpg
Type: image/jpeg
Size: 61695 bytes
Desc: not available
URL: 
<http://autox.team.net/pipermail/healeys/attachments/20180824/336bfd27/attachment-0001.jpg>

<Prev in Thread] Current Thread [Next in Thread>