I use Edward's idea but use the crimpers that don't break the plastic
seal...these have worked great for many years in our tough marine
enviroment ....salt water and a rough seas...TR never sees this ...I hope !
Both ways are good.
On Wed, Aug 7, 2013 at 3:24 PM, Tony Drews <tony@tonydrews.com> wrote:
> I solder anything I can. I usually run some heat shrink tubing over the
> joint between the connector and the wire after soldering. I make an effort
> to minimize the number of connections / connectors too. Every connection
> is a possible point of failure.
>
> Tony Drews
>
>
> At 02:13 PM 8/7/2013, Christopher Bock wrote:
>
>> Amici
>>
>> What is the best practice for electric connections, crimp or solder?
>>
>> Chris
>> ______________________________**_________________
>> fot@autox.team.net
>>
>> http://www.fot-racing.com
>>
>> Donate: http://www.team.net/donate.**html<http://www.team.net/donate.html>
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage: http://autox.team.net/mailman/**
>> options/fot/tony@tonydrews.com<http://autox.team.net/mailman/options/fot/tony@tonydrews.com>
>>
> ______________________________**_________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.**html<http://www.team.net/donate.html>
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/**
> options/fot/rfdeanes@gmail.com<http://autox.team.net/mailman/options/fot/rfdeanes@gmail.com>
>
>
>
--
rob deanes
TR Racer
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|