When they did my 240 they put tape on the moulding to hold it in place and
used soapy water to make the moulding slip into place. Of course they also
had other special tools and the know-how to do it.
I leave that stuff to the pros.
Mike
----- Original Message -----
From: "steve car" <steve_car@hotmail.com>
To: <datsun-roadsters@autox.team.net>
Sent: Tuesday, October 02, 2001 7:51 PM
Subject: high windshield trim install
> Does anybody have a good method for putting the trim and gasket on the
> windshield? I know how to install the windshield in the frame but had
> nothing but trouble getting both the trim/gasket on the windshield. I
could
> get the trim on the new gasket, but when trying to put the windshield in
the
> trim would pop out from the ends. I installed the trim by sliding it
through
> the grove from the sides. I also tried putting the gasket on the
windshield
> and using a small rope, but ended up tearing the gasket.
> Thanks,
> Steve
> 69 1600
>
> _________________________________________________________________
>
> ///
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Send list postings to datsun-roadsters@autox.team.net
> ///
///
/// datsun-roadsters@autox.team.net mailing list
///
|