Just a wild guess but I think those were for building and aligning the frame as
it
was assembled.
Ron
DemonTSi@aol.com wrote:
> In a message dated 08/20/1999 8:00:21 PM Pacific Daylight Time,
> p-pie@sympatico.ca writes:
>
> << I've been cleaning up my engine bay, working toward fitting the new
> KA24DE, and I have a question about the 2 square, flat structures on
> either frame rail, almost directly above the steering box and idler
> box.....each has threaded holes, 4 each(?), as if they are for some very
> specific use, although I can't recall ever seeing anything bolted to
> them on any car I've seen. >>
>
> Do you mean those two rectangular structures with the big holes in the middle?
> ( http://members.xoom.com/_XOOM/BADROC/vansfold/sr20/sr207/sr207_1.JPG )
> I've also been wondering what their purpose is. I haven't looked too closely
> at what the frame looks like under them, but how were you going to remove
> them?
>
> Van - BTW, I've saved probably over 20 lbs just by removing all the dirt and
> grime from my frame...amazing!
> - http://members.xoom.com/BADROC
|
