In a message dated 4/3/2002 6:47:09 PM Central Standard Time, jblair@exis.net
writes:
> I'd be very interested in the name. When I did mine, I used dyna-glass
> and worked it in with a drill bit to get the concave effect. Then topped
> it
> off with some bondo and the drill bit again. I probably should have used
> seam sealer. I still have to do the rear panel to quarter panels.
>
> How do you grind the old stuff out?
>
> The best tip I've heard on this is to use a hack saw blade and carfully
> work
> /cut the old stuff out.
>
It is 3M P.R.O. Fill/Bond Rigid Parts Repair Kit. For bonding and filling SMC
and fiberglas. part #051131-05883.
I am not sure what the best way is to remove the old material. A bodyman did
mine when I had the car in for painting.
Scott
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/bricklin
|