6pack
[Top] [All Lists]

RE: Replacing front calipers with Wilwood Superlite II

To: "'Mike Munson'" <fasttrs@mindspring.com>,
Subject: RE: Replacing front calipers with Wilwood Superlite II
From: "R. Ashford Little II" <ralittle2@mindspring.com>
Date: Mon, 17 Feb 2003 11:22:45 -0500
Mike, can you identify any of this kit, or who mocked this up?

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=2404127003
&category=6033


R. Ashford Little II
www.geocities.com/ralittle2


-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net] On
Behalf Of Mike Munson
Sent: Friday, February 14, 2003 7:21 PM
To: 'Shane Ingate'; '6 Pack'
Cc: LaJoMor@aol.com
Subject: RE: Replacing front calipers with Wilwood Superlite II

Shane ,

I have seen people run spacers before; however don't you think there is
enough room in piston movement to allow for 1/8" offset? If not I would
use hardened washers with the same outside diameter as the caliper to
bracket footprint.
I know they will be heavier but I just bought all the parts for the
Toyota conversion. Here is a price breakdown.

2 used calipers for core trade in                 35.00
2 rebuilt calipers                                61.22
2 hardware kits                                    8.00
1 set of Carbotech Panther plus pads & shipping  142.00
1 misc. hardware for brake lines                   4.00
                                     Total       246.22

Because I have 3 Triumphs I decided to go with the cheaper setup. Also
this is the street car that has rear disc brakes and I am trying to
balance the braking system.
In my best guess the difference in pad surface area is Stock late model
(16pb) 5.7"sq. The Toyota pad 6.8" sq. A difference of approximately
1.1" sq. Also looks to be approximately .3" sq. over the Jaguar pad.

When I get them on I will let you how they work out.

Mike  



-----Original Message-----
From: Shane Ingate [mailto:hottr6@hotmail.com] 
Sent: Friday, February 14, 2003 10:54 AM
To: 6 Pack
Cc: Mike Munson; LaJoMor@aol.com
Subject: Replacing front calipers with Wilwood Superlite II

All,

Sorry if I have been bombing the list recently; I think I must be
smelling
Spring in the air.

Topic for today's discussion is replacing the front stock brake calipers
with 4-pot Wilwood Superlite II calipers (about $210/pr).

The stock disk has a thickness of 0.5".  The stock caliper weighs
10.5lbs,
has 3.5" bolt mount centers, with 1.024" mount offset.

The Wilwood Superlite II weighs 3.75lbs, 3.5" bolt mount centers, and
for a
disk with 0.5" thickness, has 1.151" mount offset.

Can I shim the Superlite II 1.151" - 1.024" = 0.127"?  If so, how?
Could I
use washers, or would I have to machine a plate from aluminum stock?
This
would then be a bolt-on job, at considerably less cost and weight than
using
the Toyota pick-up truck or Jaguar XJ-6 calipers.  Looks cooler too.

Shane Ingate, with Spring Fever in Maryland

<Prev in Thread] Current Thread [Next in Thread>