Thanks for the input,everyone.
Tom
>From: levilevi <levilevi@comcast.net>
>Date: 2006/12/15 Fri PM 04:27:43 CST
>To: triumphs@autox.team.net, Tom Note <tom628@verizon.net>
>Subject: Re: [TR] TR6 manifold gasket
>If your manifold is flat then no sealer should be necessary. Take a straight
>edge and put it on the mating surface at a number of places and angles. If
>theres high spots you should get a machinist to take them down if you don't
>want to grind them yourself.
>
>Bud
>
>71TR6 CC57365 (Good 6)
>66TR4A CTC57806 (The Wreck-Almost Parts)
>66TR4A CTC57529 (The Project)
>71F-250 Camper Special (Triumph Support Vehicle)
>Z-50A Hardly Davidson 1977 Honda Mini-Trail Bike (Triumph Pit Bike)
> ----- Original Message -----
> From: Tom Note
> To: triumphs@autox.team.net ; triumphs@autox.team.net
> Sent: Thursday, December 14, 2006 9:31 PM
> Subject: [TR] TR6 manifold gasket
>
>
> Hi All:
>
> Is it advisable to coat the manifold gasket with gasket cement/sealer before
>installation?
> If so, any recommendations?
>
> Thanks,
> Tom
>
> Your messages not reaching the list?
> Check out http://www.team.net/posting.html
>
> === This list supported in part by The Vintage Triumph Register
> === http://www.vtr.org
>
> === Help keep Team.Net on the air: http://www.team.net/donate.html
>
> === unsubscribe/change address requests to majordomo@autox.team.net
> === Archives at http://www.team.net/archive
> === http://www.team.net/the-local
>
>Your messages not reaching the list?
>Check out http://www.team.net/posting.html
>
>=== This list supported in part by The Vintage Triumph Register
>=== http://www.vtr.org
>
>=== Help keep Team.Net on the air: http://www.team.net/donate.html
>
>=== unsubscribe/change address requests to majordomo@autox.team.net
>=== Archives at http://www.team.net/archive
>=== http://www.team.net/the-local
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|