If your manifold is flat then no sealer should be necessary. Take a straight
edge and put it on the mating surface at a number of places and angles. If
theres high spots you should get a machinist to take them down if you don't
want to grind them yourself.
Bud
71TR6 CC57365 (Good 6)
66TR4A CTC57806 (The Wreck-Almost Parts)
66TR4A CTC57529 (The Project)
71F-250 Camper Special (Triumph Support Vehicle)
Z-50A Hardly Davidson 1977 Honda Mini-Trail Bike (Triumph Pit Bike)
----- Original Message -----
From: Tom Note
To: triumphs@autox.team.net ; triumphs@autox.team.net
Sent: Thursday, December 14, 2006 9:31 PM
Subject: [TR] TR6 manifold gasket
Hi All:
Is it advisable to coat the manifold gasket with gasket cement/sealer before
installation?
If so, any recommendations?
Thanks,
Tom
Your messages not reaching the list?
Check out http://www.team.net/posting.html
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
=== Help keep Team.Net on the air: http://www.team.net/donate.html
=== unsubscribe/change address requests to majordomo@autox.team.net
=== Archives at http://www.team.net/archive
=== http://www.team.net/the-local
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|