Joe,
Thanks....the linkage and hoses are fine, no kinks or bent linkage.
I will retorque studs, but I got 'em pretty good initially...all new studs and
custom fitted the gasket from Mr. Gasket "you make it" style gasket material,
carefully matched all ports and stud and alignment pin holes.
Thanks again for the input, I'll keep y'all posted
Chris Prugh
72 Spitfar
Morgan Hill, CA
----------
From: Joe Curry[SMTP:spitlist@gte.net]
Sent: Monday, February 23, 1998 3:53 PM
To: Chris Prugh
Subject: Re: HEELLLLLPPPPPP!
Chris,
The thing that screams out louder than you is the fact that you took off
the Intake manifold in order to install the exhaust. In doing so, did
you get any of the linkage or hoses streatched, bent, broken, spindled
or otherwise mutilated? Also, you might check to ensure that you gor a
good fir on the intake/exhasust gasket. If not, it could be sucking air
around there instead of from the carb.
Hope this helps!
Joe
Chris Prugh wrote:
|