To: | Biff Jones <biffjones@erols.com> |
---|---|
Subject: | Re: Crank discussions |
Date: | Wed, 18 Oct 2000 05:23:47 -0500 |
Cc: | spidgets <spridgets@autox.team.net> |
Organization: | Computer Helpers |
References: | <007101c0385c$06f46300$1f95accf@default> |
I wouldn't worry about it. Actually you've measured the mains to be half a thousandth OVER, not under. That's a pretty samll figure. You may be flirting with the limits of accuracy of your mike. You could tell your machine shop to micro-polish the journals to stock specs, for peace of mind. Then run std bearings. Be sure to plastiguage each journal. Cheers, CR |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Tensile strength of bolts in re: Torque, Unknown |
---|---|
Next by Date: | Re: Tensile strength of bolts in re: Torque, Unknown |
Previous by Thread: | Re: Crank discussions, Unknown |
Next by Thread: | More on tools, Unknown |
Indexes: | [Date] [Thread] [Top] [All Lists] |