I don't understand, your crank is BIGGER that the stock spec?
Is that a typo in your message?
Ulix
on 10/17/00 10:02, Biff Jones at biffjones@erols.com wrote:
> All,
>
> With the current discussions re turning a crank I have the
> following question;
> I acquired a 1275 crank which shows signs that it has been
> recently worked on.
> The rod journals mike out at 1.6259 (actually 1.626) which
> according to the manuals the upper end of stock, however the
> mains mike at 2.0015. Stock manual measurements state 2.0005 to
> 2.0010, can I run it as is, being .0005 under with stock
> bearings, or should I have it turned down to 10 thousands under?
> I am at the point of having it and the fly wheel worked on and
> need advice. Thanks,
> Biff Jones
> Pasadena, MD
> '59 Bugeye, "Kermit'
> '62 Sprite, 'Ole Gray'
> http://sprites2.homestead.com/index.html
>
>
Ulix __/__,__ ___/__|\__
..............................................(_o____o_)....<_O_____O_/...
http://www.mirafiori.com/~ulix/ '67 Sprite '74 X1/9
|