I've heard Bon.....
never mind
At 12:02 PM 10/17/2000, Biff Jones wrote:
>All,
>
>With the current discussions re turning a crank I have the
>following question;
>I acquired a 1275 crank which shows signs that it has been
>recently worked on.
>The rod journals mike out at 1.6259 (actually 1.626) which
>according to the manuals the upper end of stock, however the
>mains mike at 2.0015. Stock manual measurements state 2.0005 to
>2.0010, can I run it as is, being .0005 under with stock
>bearings, or should I have it turned down to 10 thousands under?
>I am at the point of having it and the fly wheel worked on and
>need advice. Thanks,
>Biff Jones
|