Bob,
I bought a Northern with a 5 HP Honda Engine and Ceramic pistons about 12
years ago. I replaced the pump seals and one cracked piston at about 5 years
and then replaced the pump a couple years ago. It uses a "General" pump and
has seen a lot of use. Pressure is good but so is volume. I have seen higher
pressure units that blow the dirt farther but don't do any more work. I think
mine is about 2200 PSI. Prices have generally come down since I bought mine
but I think it was about $500 in 95. I use it all of the time and have run it
10 hours a day cleaning the driveway. I haul it to the boat a few times a
year and clean up nasty old chassis rails every now and then. I do use it to
wash cars but am careful to keep my distance from the paint, it think it could
blow it off.
Mark
Nashville
http://www.ArrestMeRed.com
----- Original Message -----
From: Bob Nogueira
To: Shop Talk
Sent: Wednesday, May 28, 2008 2:22 PM
Subject: Re: [Shop-talk] Pressure washers
Okay went out this morning for coffee and stopped in a few places and
looked
at pressure washers. Found a couple of good deals at Northern tool and at
Lowes (Troy Built) . Both the same pressure and accessories. Differences
are
Honda engine vs a Briggs and Stratton and ceramic piston vs Stainless steel
piston. I know the Honda engine is good but I have also had good luck with
Briggs & Stratton the last few years so that's pretty much a wash. Now
which
would be better, ceramic pump piston or stainless steel piston.
Bob Nogueira ( Ain't Retirement Great!!!)
_______________________________________________
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|