shop-talk
[Top] [All Lists]

Re: [Shop-talk] hand tool recommendations that don't break the bank

To: "Mark Andy" <mark@sccaprepared.com>, <shop-talk@autox.team.net>
Subject: Re: [Shop-talk] hand tool recommendations that don't break the bank
From: "Eric J Russell" <ejrussell@mebtel.net>
Date: Tue, 4 Mar 2008 19:03:40 -0500
For a tool that I will only use rarely, H-F is often adequate.

For a tool that will get occasional or frequent use, better quality is 
a worthwhile investment.

I do often use a Stanley "6 in 1" screwdriver (and I keep one each 
vehicle). It has a large & small flat blade, a large & small phillips, 
plus two sizes of hex drive (1/4" & 5/16" I think). Its only draw back 
is for situations where you need to reach down into a small access 
hole - the shank is larger in diameter than a standard screwdriver.

<http://www.stanleytools.com/default.asp?CATEGORY=SCREWDRIVER+SET&TYPE=PRODUCT&PARTNUMBER=62-524&SDesc=6+in+1+Screwdriver>

Eric Russell
Mebane, NC
http://home.mebtel.net/~ejrussell

----- Original Message ----- 
From: "Mark Andy"
> Anyone have any hand tool recommendations for tool buying on a 
> budget?
> I'm outfitting a 2nd toolbox for the race car trailer. 
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


Shop-talk mailing list

http://autox.team.net/mailman/listinfo/shop-talk

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>