The bearing in the face plate on my generator is deteriorated and needs
to be replaced. Unfortunately, the inner race seems to have annealed to
the armature shaft - or is just a very tight fit. I have soaked it with
penetrating oil and whacked the end of the shaft with a large hammer,
with the nut on the shaft, to break it apart. But no luck. Any advice
as I don't want to break anything and generators are hard to find and
expensive..
Larry Swift
51 mgtd
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|