healeys
[Top] [All Lists]

Re: [Healeys] Steering Arm Removal

To: <jjkbj7@yahoo.com>, <healeys@autox.team.net>
Subject: Re: [Healeys] Steering Arm Removal
From: "Elton Schulz" <eschulz@frontiernet.net>
Date: Fri, 2 May 2008 23:24:26 -0400
I found that a pitman puller works a lot better than a gear puller to get 
the steering arm off. The pitman puller is a lot sturdier.
Elton
BJ7 in progress
----- Original Message ----- 
From: "John Kuzman" <jjkbj7@yahoo.com>
To: <healeys@autox.team.net>
Sent: Friday, May 02, 2008 7:51 AM
Subject: [Healeys] Steering Arm Removal


>   I need some guidance on the removal of the steering arm from the
>   steering box on my BJ7. I am attempting to replace the seal.
>
>   I removed the large nut and washer and soaked the joint with PB
>   Blaster for over a week. I attached a puller and tightened the puller
>   down to the point of almost deforming the puller and the arm has not
>   budged. I did not remove the steering side rods from the other end of
>   the steering arm. Do these need to come off to remove the arm from the
>   steering box splined shaft? Any other suggestions? Thanks.
>     _________________________________________________________________
>
>   Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try
>   it now.
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as eschulz@frontiernet.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>