I need some guidance on the removal of the steering arm from the
steering box on my BJ7. I am attempting to replace the seal.
I removed the large nut and washer and soaked the joint with PB
Blaster for over a week. I attached a puller and tightened the puller
down to the point of almost deforming the puller and the arm has not
budged. I did not remove the steering side rods from the other end of
the steering arm. Do these need to come off to remove the arm from the
steering box splined shaft? Any other suggestions? Thanks.
_________________________________________________________________
Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try
it now.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|