While you have the puller on the arm, under tension, put some hear on the arm.
Use an oxy-acetalene torch - not a little propane torch. Stand back. Richard
Mayor
> Date: Fri, 2 May 2008 04:51:08 -0700> From: jjkbj7@yahoo.com> To:
healeys@autox.team.net> Subject: [Healeys] Steering Arm Removal> > I need some
guidance on the removal of the steering arm from the> steering box on my BJ7.
I am attempting to replace the seal.> > I removed the large nut and washer and
soaked the joint with PB> Blaster for over a week. I attached a puller and
tightened the puller> down to the point of almost deforming the puller and the
arm has not> budged. I did not remove the steering side rods from the other
end of> the steering arm. Do these need to come off to remove the arm from
the> steering box splined shaft? Any other suggestions? Thanks.>
_________________________________________________________________> > Be a
better friend, newshound, and know-it-all with Yahoo! Mobile. Try> it now.>
_______________________________________________> Support Team.Net
http://www.team.net/donate.html> > Healeys@autox.team.net>
http://autox.team.net/mailman/listinfo/healeys> > You are subscribed as
mayorrichard@hotmail.com> > http://www.team.net/archive
_________________________________________________________________
Get Free (PRODUCT) RED Emoticons, Winks and Display Pics
http://joinred.spaces.live.com?ocid=TXT_HMTG_prodredemoticons_052008
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|