On My BJ8, I wrapped a chain around the rear exhaust manifold tube and the
front generator mount.
Ned Smith
BJ8
near Chattanooga, TN
N34.89, W85.47
-----Original Message-----
From: owner-healeys@autox.team.net [mailto:owner-healeys@autox.team.net] On
Behalf Of Greg Lemon
Sent: Monday, October 16, 2006 3:45 PM
To: Healeys@autox.team.net
Subject: Pulling the Motor BN1
I am about to pull the motor of my BN1 for the often rumored engine rebuild
I am finally going to undertake.
I do not have the special service tool mentioned in the manual, any
suggestions as to lifting attachment points on the motor?
I have pulled a few engines before, but mostly Sprite, with a lot less mass
so want to make sure it is held securely.
Any other hints from those who have been there, done that would be
appreciated, I do have and have read the factory manual.
Greg Lemon
54 BN1
|