Greg --
Be exceedingly careful when hoisting the engine -- don't bump the crankshaft
pulley! We discovered they break very easily and a new one is very
expensive!
Sarah Carr
BN1 in PA
----- Original Message -----
From: "Greg Lemon" <glemon@neb.rr.com>
To: <Healeys@autox.team.net>
Sent: Monday, October 16, 2006 3:45 PM
Subject: Pulling the Motor BN1
>I am about to pull the motor of my BN1 for the often rumored engine rebuild
>I am finally going to undertake.
>
> I do not have the special service tool mentioned in the manual, any
> suggestions as to lifting attachment points on the motor?
>
> I have pulled a few engines before, but mostly Sprite, with a lot less
> mass so want to make sure it is held securely.
>
> Any other hints from those who have been there, done that would be
> appreciated, I do have and have read the factory manual.
>
> Greg Lemon
> 54 BN1
|