Pulling the Motor BN1

["Greg Lemon" <glemon@neb.rr.com>]

I am about to pull the motor of my BN1 for the often rumored engine rebuild 
I am finally going to undertake.

I do not have the special service tool mentioned in the manual, any 
suggestions as to lifting attachment points on the motor?

I have pulled a few engines before, but mostly Sprite, with a lot less mass 
so want to make sure it is held securely.

Any other hints from those who have been there, done that would be 
appreciated, I do have and have read the factory manual.

Greg Lemon
54 BN1