ATI part numbers for TR 2,3 and 4 are: 918569 for the AL. shell @ around $425
and 916789 for the crankshaft hub @ around $125 from ATI Summit and Jegs may
also carry these units.
On Dec 3, 2013, at 3:34 PM, Dan Cronin wrote:
They can be purchased directly from the folks at ATI, thats where I got mine
s
couple of years ago.
On Dec 3, 2013, at 1:14 PM, toodamnfunky@comcast.net wrote:
FoT
I have the Moss B= pulley and belt conversion with the rubber joint on the
crank pulley/dampener.
Kas warned me at Elkhart lake that these can separate and with that I would
like to explore higher quality
crank dampeners. We installed an ATI super damper on Mark Edenbs car and
there are three things about it I donbt like.
1. Cost + $ 500.00
2. They are not clocked correctly for the TR4 and a new timing pointer
needs to be fitted in a less than ideal position.
3. With the engine installed there is only B<b clearance to the steering
rack.
B
So with that I have been looking at OEM and aftermarket dampeners/balancers
for other cars but I just donbt know
enough about machining to determine if it would be worth trying to machine a
balancer from another make to fit the TR4.
B
While on the subject of pullies in general Ibm wondering what others have
done with non-Triumph parts.
I would prefer a serpentine belt. I know I could fit a good quality tensioner
but still stuck on fitting non-triumph pullies
to the TR-4.
Can anyone advise on this subject ?
Thanks,
jim g
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/fot/adcronin@mi.rr.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/fot/adcronin@mi.rr.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|