I just checked with Dave Bean and they said that they can install the 7/16 - 20
either 1" long or protruding 2.3 ". So it looks like the 7/16 is ok I just need
to figure on which stud length.
Bill B
-----Original Message-----
From: Joe Curry [mailto:Spitlist@gte.net]
Sent: Tuesday, February 25, 2003 2:43 PM
To: Gt6steve@aol.com
Cc: Bill Bartlett; FOT@autox.team.net
Subject: Re: GT6 Wheel studs
Gt6steve@aol.com wrote:
>
> Bill,
> The alloy hubs will likely be drilled for the stock 3/8" studs so you'll have
> to bore them to take whatever studs you're using. The 7/16-20 upgrade is
> most likely a Chevy size. If not, look to use them as you can get a
> replacement stud at any tire store. I recommend the ARP studs but that's up
> to you.
> Steve
Steve (and all)
The stock hubs take the larger studs without modification so I don't
know why the alloy ones would need to be modified. The smaller studs
have a shank that is the same size as the TR6 studs. So it should not
be necessary to re-size them.
Joe (C)
|