On Wed, 23 Jan 2008 forzion@maine.rr.com wrote:
> Marty;
>
> bolt. I believe the seat belt bolts themselves are 7/16" dia. But the
> drill bits I finally ended up starting with were 1/8" dia. After I
> succeeded in drilling through (on center using a punch) with that, I
> proceeded then to 3/16" dia., then 1/4, etc... After all the effort,
I know these are 20 pitch... fine thread.
I guess you're right that they're 7/16" though.
> Good luck!
>
> Dave
> CF25194U+O+TBI
Yer right, though, this job is a GPITA
rml
---------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT IS&T unix-linux-help |
Voice:617-253-7438 FAX: 617-258-9535 | Cell: 339-927-4489
---------------------------------------------------------------------------
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|