[TR] carb issues and stalling
CFMTR3A
cfmtr3a at verizon.net
Fri Nov 6 06:29:09 MST 2015
Upon closer inspection, one end of the nylon was not connected to the
element frame. Thanks Randall.
Carl
-----Original Message-----
From: Triumphs [mailto:triumphs-bounces at autox.team.net] On Behalf Of CFMTR3A
Sent: Wednesday, November 4, 2015 10:24 PM
To: 'Randall' <TR3driver at ca.rr.com>; 'Truiumphs' <triumphs at autox.team.net>
Subject: Re: [TR] carb issues and stalling
It is a nylon mesh element. I didn't see any tears in it but will look more
closely in the morning. Thanks
My neighbor is into old bikes (Indian & Harley). He suggested using a
filter that has a porous metal element. Any thoughts? (I think it is
bronze or brass and is also used in golf carts, etc.)
C
-----Original Message-----
From: Triumphs [mailto:triumphs-bounces at autox.team.net] On Behalf Of Randall
Sent: Wednesday, November 4, 2015 8:51 PM
To: cfmtr3a at verizon.net; 'Truiumphs' <triumphs at autox.team.net>
Subject: Re: [TR] carb issues and stalling
> Fuel filter before the pump - major sediment. Cleaned it. It was so
> dirty that the grunge was getting past the filter.
So this is just a screen-type filter? If a paper element filter was letting
grunge through, it was defective, not just dirty.
It also sounds like you may be missing the fine brass screen that goes above
the sediment bowl; and/or have deteriorating rubber lines.
Randall
More information about the Triumphs
mailing list