[TR] Spring compressor

[Jerry Van Vlack]

You can make your own with a length of 1/2 in all thread, nuts, large washers and a block of 2x4. I’ve used mine several times.
JVV

From: Keith Stewart 
Sent: Tuesday, December 23, 2014 3:23 PM
To: triumphs at autox.team.net 
Subject: Re: [TR] Spring compressor

On Dec 23, 2014, at 1:41 PM,James Henningsen wrote:




  Anyone know a good brand of coil spring compressor for TR4?  I would like to
  purchase one, but one I borrowed from local parts place is too big to fit
  inside coil spring.

  Thanks,

  Jim Henningsen


TRF sells a remake of the original factory tool. It can be purchased with two plates - one for TR4s and the other for TR4As. The usual FLAPS ones can be dangerous (the external hook type). This tool uses a threaded rod down the centre of the spring.


Keith Stewart
<<< please note my new email address below >>>
keithstewart at bell.net







--------------------------------------------------------------------------------


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20141223/dfb5480f/attachment.html>