[TR] Moss TR6 Fuel Pump Reproduction

[alan salvatore]

Thats the same on the TR6 pump.  On the inside of the pump the lines bottom
out on the inside of the housing so the compression sleeve will collapse
when the fitting nut is screwed down.
On the reproduction, they made the inside of the housing the same 5/16  on
both sides so that the 1/4 pipe passes through it and the compression
sleeve can't be compressed by the nut.


Al

On Sat, Jun 16, 2012 at 8:48 PM, Randall <TR3driver at ca.rr.com> wrote:

> > The Moss pump has the same larger size on both the inlet and
> > outlet.
>
> I don't know if this applies to the TR6 pump or not; but on the TR3A-4A the
> pump inlet and outlet fittings were the same size but the lines were
> different sizes. (5/16" inlet, 1/4" outlet).  This magic was accomplished
> with a special fitting nut, that screwed into the 5/16" port but took a
> 1/4"
> line and compression sleeve.
>
> The TR6 pump isn't quite the same, but it looks similar enough that I'll
> bet
> it used the same setup.
>
> -- Randall