[TR] TR3 Breather Pipe fitting

[Tony Drews]

I did it with a skinny right angle attachment on a regular drill and 
a LOT of 4 letter words, but that was in a TR-4, not a 3.

- Tony D

At 06:41 PM 9/26/2010, Carl TR wrote:
>I asked this question below - cannot find the response (if there were any)
>and searching the archive came up empty.
>
>
>When rebuilding the engine for the '3 project, I used a plug in the breather
>pipe block hole.  Forgot to pull it out before installing the engine.    Now
>I am trying to install that pipe and cannot figure out how to get the plug
>out.
>
>There isn't enough room to get a drill or any other tool.  Any suggestions?
>
>I have a right angle drill but there isn't even clearance for that.
>
>What about a 1" hole in the wheel well to access it and then plugging with
>the 1" plug like on the firewall?  Frustrating afternoon.
>
>Thanks
>Carl
>
>_______________________________________________
>Triumphs at autox.team.net
>Donate: http://www.team.net/donate.html
>Suggested annual donation  $11.47
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe: http://autox.team.net/mailman/options/triumphs/tony@tonydrews.com