[TR] TR4/Webers - that banging noise- #2

[Tony Drews]

Of course, you can do the same with the wrist pin...

- Tony

At 11:02 AM 8/8/2009, Lee&John Howard wrote:
>Excellent idea, Tom. I'll do that and report back.
>John
>
>On Sat, Aug 8, 2009 at 8:19 AM, tom white <tswhitez123 at hotmail.com> wrote:
>
> >  You say the rod bearing was in place and torqued properly.  To be certain
> > the bearing is OK you need to measure the clearances with a micrometer.
> > Measure the rod journal and note the diameter.  Then place the rod bearing
> > in the rod cap and torque the cap while the rod is off of the crank.  Then
> > measure th inside diameter of the bearing.  Subtract the journal diameter
> > fromt the bearing diameter to get the amount of clearance.  Compare your
> > answer to book specs.
> >
> > Best regards, Tom