[TR] Replacing rear brake cyls.

[Ed Woods]

With all due respect, the Danielson method is doing it the hard way. The 
three pieces are orientated properly in the photos, but the order of 
assembly should be:
1. Insert the long piece, with the locking tabs up, from the brake lever 
side.
2. Insert the shortest piece, also from the brake lever side
3. Insert the brake lever
4. Insert the remaining long piece between the first two pieces from the 
side opposite the brake lever until the tabs from the bottom piece lock in 
place. You'll have to tap it home with a light hammer and a punch or screw 
driver.
5. Install the dust cover. It does NOT go between the 1st plate and the 
backing plate, but fits the periphery of the 3 plate assembly. If it was 
placed under the first plate, it would prevent the assembly from sliding 
along the backing plate easily.

Ed Woods

And, yes, rubber grease, Girling green or equivalent, should be used 
throughout, especially between the brake cylinder and the backing plate.