[TR] TR3 hard to slide into 1st gear

[Francis P. Gowash]

Had similar problem and after fiddling with adjustments found that replacing
slave cylinder corrected shifting problem.

Fran
CT
58 TR3A

-----Original Message-----
From: triumphs-bounces+fpgowash=cox.net at autox.team.net
[mailto:triumphs-bounces+fpgowash=cox.net at autox.team.net]On Behalf Of
Kent Shrack
Sent: Wednesday, March 26, 2008 9:38 AM
To: triumphs at autox.team.net
Subject: [TR] TR3 hard to slide into 1st gear


My wife is having difficulty in shifting her TR3 into first gear at a stop.
I have worked with her on letting the clutch out slightly etc, but it's like
it just will not slide into gear for her.  I don't have as much trouble, but
it is difficult at times.  It is a non-syncro overdrive.  Before installing
it I put in bearings, seals and syncro's, but did nothing to the top cover
or shifter slides.  From the wisdom of the list, Is the top cover the best
place to start?  Clean shafts, new seals, and shift shaft lubrication?  What
is the recommended lubricant that will stay without attracting too much
dirt?   Any help is ALWAYS appreciated

  THANKS

  Kent Shrack TS78563 o


---------------------------------
Be a better friend, newshound, and know-it-all with Yahoo! Mobile.  Try it
now.
This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs at autox.team.net
http://autox.team.net/mailman/listinfo/triumphs

You are subscribed as fpgowash at cox.net

http://www.team.net/archive