[TR] Clutch M/C Impact

[tom white]

When I installed my Tilton HTOB I also installed their short length
recommended 5/8" clutch master cylinder.  It fits the TR mounts perfectly and
is very reasonable on the foot pressure.  The system has worked extremely
well.

Best regards,
Tom

> From: 75TR6 at tr6.danielsonfamily.org
> To: triumphs at autox.team.net; 6pack at autox.team.net
> Date: Sun, 2 Mar 2008 08:41:25 -0500
> Subject: [TR] Clutch M/C Impact
>
> When I drained my clutch M/C and looked inside there was dark gray/black
> gunk inside. That can't be good, so I may install a new clutch M/C with the
> Toyota 5 speed installation and wonder if the early TR6 clutch M/C with a
> .75 bore is compatible with the later cars that had a .70 bore? And what
> would the impact be on clutch feel which will now have an hydraulic throw
> out bearing? Would it make it feel lighter or heavier? And I'll also check
> with Herman in case it impacts the tranny install.
>
> Thanks
>
> Bob
>
> Bob Danielson
> 1975 TR6 CF38503U
> Running w/ Throttle Body Injection
> http://tr6.danielsonfamily.org
>
> No virus found in this outgoing message.
> Checked by AVG.
> Version: 7.5.516 / Virus Database: 269.21.3/1306 - Release Date: 3/1/2008
> 5:41 PM

_________________________________________________________________
Climb to the top of the charts! Play the word scramble challenge with star
power.
http://club.live.com/star_shuffle.aspx?icid=starshuffle_wlmailtextlink_jan