[TR] [6pack] Clutch M/C Impact

[Chuck Arnold]

Bob,
I used a Tilton .75" clutch MC with the Herman 5 speed and linear throwout
bearing.  Worked just fine.  Be real sure to follow his directions on how
much [little] clutch travel you need to work the bearing -- too much ruins
it.

On Sun, Mar 2, 2008 at 5:41 AM, Bob Danielson <75TR6 at tr6.danielsonfamily.org>
wrote:

> When I drained my clutch M/C and looked inside there was dark gray/black
> gunk inside. That can't be good, so I may install a new clutch M/C with
> the
> Toyota 5 speed installation and wonder if the early TR6 clutch M/C with a
> .75 bore is compatible with the later cars that had a .70 bore? And what
> would the impact be on clutch feel which will now have an hydraulic throw
> out bearing? Would it make it feel lighter or heavier? And I'll also check
> with Herman in case it impacts the tranny install.
>
> Thanks
>
> Bob
>
> Bob Danielson
> 1975 TR6 CF38503U
> Running w/ Throttle Body Injection
> http://tr6.danielsonfamily.org
>
> No virus found in this outgoing message.
> Checked by AVG.
> Version: 7.5.516 / Virus Database: 269.21.3/1306 - Release Date: 3/1/2008
> 5:41 PM
>
> _______________________________________________
>
> Support Team.Net  http://www.team.net/donate.html
>
> 6pack at autox.team.net
> http://autox.team.net/mailman/listinfo/6pack
>
> http://www.team.net/archive
>
> You are subscribed as triosan at gmail.com
>
>


-- 
Chuck Arnold