[Tigers] Parts Request

[Ron Fraser]

Allan

                Interesting picture – it looks like a Tiger part but not with those port sizes.

I never studied the Temp housing on my Tiger before installation so I don’t know if there is a number stamped into it.

 

Port sizes for the Tiger part has to be 2, 5/8” hose ports for the stock 5/8” hose from the intake manifold elbow to the carb spacer and 1, ½” hose port for the ½” hose to the heater valve.

 

It appears you have a Temp Housing from a different British vehicle.

 

Ron Fraser

 

From: Tigers <tigers-bounces at autox.team.net> On Behalf Of Allan Ballard via Tigers
Sent: Friday, August 10, 2018 5:58 PM
To: tigers at autox.team.net
Subject: Re: [Tigers] Parts Request

 

Ron,

Here's a temp-sender housing I've had for long enough to forget where it came from. I thought it

was "factory issue" but the numbers don't match so I guess it isn't. It is stamped: 198006 v12 and

appears to be cast. If I am measuring correctly with a balky tape measure the ports are 5/8, 3/4 and 1/4.

I use an F4b intake with a different setup so I don't have a way to see "if it fits" but it appears to be close.

If it does fit and can be identified, then maybe it could be used on a Tiger.

 

 

On 8/10/18 10:29 AM, Will Seay via Tigers wrote:

Randall,

 

You may be able to find the copper 'T' fitting at a plumbing supply place.  The temp-sender housing is unique to the Tiger and will be hard to find.

 

Good luck


-- 

Will - 382001570 
 <mailto:Tigers at embarqmail.com> Tigers at embarqmail.com

 

 

On Thu, Aug 9, 2018 at 8:40 PM, Ron Fraser via Tigers <tigers at autox.team.net <mailto:tigers at autox.team.net> > wrote:

Randall 

 

Rear fitting as shown = 1224827                 “T” fitting

Front fitting as shown = 1222826                Housing Temperature transmitter – this is a cast part for the temp sender

These are for the Mk I & Mk IA parts

 

Mk II has 2 – 1224827      T fitting

 

1224827                T fitting is brass or copper I don’t know for sure – this part could be made – 2, 5/8” hose ports and 1, ½” hose port

 

I don’t think anyone is remaking this part but you never know; maybe someone is making them.

 

Ron Fraser






_______________________________________________
 
tigers at autox.team.net <mailto:tigers at autox.team.net> 
 
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/tigers
 
Unsubscribe: http://autox.team.net/mailman/options/tigers/aballard@ix.netcom.com
 
 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/tigers/attachments/20180811/9a5a01e0/attachment.html>