[Tigers] Fuel guage and instrument stabilizer

jim jim at island.net
Sat Jul 28 19:27:57 MDT 2012


I often check gauges with my Smiths instrument tester... I'd never actually
put voltage straight to the gauge...

9 volts is actually 3/4 of 12... but the voltage stabilizer is supposed to
put out 10 volts to the gauge...  I just tried a known good water temp gauge
@ both 9 and 10 volts and it was right on the calibration marks at the top
right of the gauge with either voltage


Jim
B382000446




-----Original Message-----
From: tigers-bounces at autox.team.net [mailto:tigers-bounces at autox.team.net]
On Behalf Of genepadgett at comcast.net
Sent: Saturday, July 28, 2012 4:11 PM
To: Rollright at aol.com
Cc: tigers at autox.team.net
Subject: Re: [Tigers] Fuel guage and instrument stabilizer

As I recall, it is bolted (1 bolt through a tab) to one of the lower fore-
to- aft dash brace arms that support the wooden dash. If you still have the
original wiring harness, the light green and green wires from the gas and
temp gauges both go to the stabilizer. So you could just follow the wires
back to the unit. 

By the way, if you put a new 9 volt battery across either gauge, it should
read 2/3 of full scale, since 9 volts is 2/3 of 12 volts. At least a 1 point
check of the gauge to see if it is working properly. 

Gene 

----- Original Message -----
From: Rollright at aol.com
To: tigers at autox.team.net
Sent: Saturday, July 28, 2012 4:54:06 PM
Subject: [Tigers] Fuel guage and instrument stabilizer 

Hello, 

I had a fuel gauge that read pretty well in the top 2/3 of its range, but
then droped like a stone. Tod Brown sent me another one so I could swap it
out. In doing so, I now have lost reading on either fuel gauge as well as
the temperature gauge. Wipers and tack work, so its not the fuse. 

A couple of times during fuel gauge install, and re-install, and
re-re-install, both of the fuel gauges pegged all the way to the right. Not
correct as both had indicated before the dual problems of pegging and
deadness about 4 gallons. 

Maybe I fried the instrument stabilizer? Where the hell is that little
devil? I know its behind the dash but where? WS manual doesn't say; only
says behind the dash. 

How come whenever you try and improve something that is working pretty well,
but not perfectly, you end up making it worse? HEL P! Wires are hanging out
of the dash.... 

Jim Armstrong
Mk 1A
382002083
LRXFE
_______________________________________________ 

tigers at autox.team.net 

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/tigers/genepadgett@comcast.net
_______________________________________________

tigers at autox.team.net

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/tigers/jim@island.net


-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.2197 / Virus Database: 2437/5160 - Release Date: 07/28/12


More information about the Tigers mailing list