[Tigers] flexplate motor to flywheel

[Tony Somebody]

Steve is right, I always replace the piolet shaft bushing BUT I have had them
almost fall out and have problems using my mechanis puller on one that had to
have been the wrong size or a bad burr-normally a greas gun will push it out
just by pumping grease in the center that gets behind and pushes it out- can
be very messy when it doesnt work- IE: the one I couldnt get out.
>________________________________
> From: Bob Dixon <bobdixon at frii.com>
>To:
"tigers at autox.tea" <tigers at autox.team.net> 
>Sent: Monday, February 27, 2012
11:55 AM
>Subject: [Tigers] flexplate motor to flywheel
>  
>Hi gang,
>
>This
may seem like a dumb question but here goes.  If you want to put a 289 that
was hooked to an automatic trans into a car with a manual trans, can you just
swap the flexplate with a flywheel?  I wasn't sure if the engine is typically
balanced by adding or removing material from the flywheel.
>
>Thanks,
>Bob
>_______________________________________________
>
>tigers at autox.team.net
>
>Donate: http://www.team.net/donate.html
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe:
http://autox.team.net/mailman/options/tigers/achd73@yahoo.com