[Spridgets] Trying to diagnose an idle/stalling issue

[Ron Soave]

I always wondered about that!

Ron Soave

> On Dec 28, 2020, at 2:30 PM, Rick Fisk via Spridgets <spridgets at autox.team.net> wrote:
> 
> Some intake manifold gaskets have a steel side.  Put the steel side against the head.
> 
> Rick
> 
> Sent from my keyboard
> 
>>> On Dec 28, 2020, at 2:11 PM, crusaderchuck55--- via Spridgets <spridgets at autox.team.net> wrote:
>>> 
>> 
>> 
>> 
>> Sent from my LG Mobile
>> Just the usual surface prep.   Clean both mating surfaces .    The intake/exhaust gaskets seem to have quite a bit of compressability in the material.   Try tightening the manifold nuts before disassembly .   Be certsin you have the thick washers under the nuts on each of the studs.   The washers spread the retaining nuts pressure in securing the manifolds.   
>> If you have brass nuts be careful of over tightening those because the steel studs try to strip the threads out of the softer brass nuts.  
>> Chuck
>> 
>> ------------------------
>> 
>> spridgets at autox.team.net
>> 
>> Donate: http://www.team.net/donate.html
>> Suggested annual donation: $12.75
>> 
>> Archive: http://www.team.net/pipermail/spridgets  http://autox.team.net/archive
>> 
>> Unsubscribe/Manage: http://autox.team.net/mailman/options/spridgets/refisk@chartermi.net
> ------------------------
> 
> spridgets at autox.team.net
> 
> Donate: http://www.team.net/donate.html
> Suggested annual donation: $12.75
> 
> Archive: http://www.team.net/pipermail/spridgets  http://autox.team.net/archive
> 
> Unsubscribe/Manage: http://autox.team.net/mailman/options/spridgets/soavero@yahoo.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/spridgets/attachments/20201228/65164072/attachment.htm>