[Spridgets] Trying to diagnose an idle/stalling issue
Rick Fisk
refisk at chartermi.net
Mon Dec 28 12:29:52 MST 2020
Some intake manifold gaskets have a steel side. Put the steel side against the head.
Rick
Sent from my keyboard
> On Dec 28, 2020, at 2:11 PM, crusaderchuck55--- via Spridgets <spridgets at autox.team.net> wrote:
>
>
>
>
> Sent from my LG Mobile
> Just the usual surface prep. Clean both mating surfaces . The intake/exhaust gaskets seem to have quite a bit of compressability in the material. Try tightening the manifold nuts before disassembly . Be certsin you have the thick washers under the nuts on each of the studs. The washers spread the retaining nuts pressure in securing the manifolds.
> If you have brass nuts be careful of over tightening those because the steel studs try to strip the threads out of the softer brass nuts.
> Chuck
>
> ------------------------
>
> spridgets at autox.team.net
>
> Donate: http://www.team.net/donate.html
> Suggested annual donation: $12.75
>
> Archive: http://www.team.net/pipermail/spridgets http://autox.team.net/archive
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/spridgets/refisk@chartermi.net
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/spridgets/attachments/20201228/13b2f2c1/attachment.htm>
More information about the Spridgets
mailing list