[Mgs] [MG-MGB] MGB Mk1 roadster seat belts

[PaulHunt73]

Thanks Kelvin - didn't know the tunnel point had moved.

PaulH.

  ----- Original Message ----- 
  From: Kelvin Dodd doddk at mossmotors.com [MG-MGB] 
  To: 'MG-MGB at yahoogroups.com' ; 'mgs at autox.team.net' 
  Sent: Tuesday, April 07, 2015 7:04 PM
  Subject: RE: [MG-MGB] MGB Mk1 roadster seat belts


    

  Paul. 



  If you are running a stowaway top there should be no problem with bow clearance. You can use a non pendulum type of belt like the one I sourced under Moss 222-216

  http://www.mossmotors.com/Shop/ViewProducts.aspx?PlateIndexID=102183



  The inner latch support is longer than normal so it will reach back to the more rearward mounting point on the tunnel on cars earlier than 1973. 



  Kelvin. 







  From: MG-MGB at yahoogroups.com [mailto:MG-MGB at yahoogroups.com] 
  Sent: Tuesday, April 07, 2015 7:54 AM
  To: mgs at autox.team.net; MG-MGB at yahoogroups.com
  Subject: [MG-MGB] MGB Mk1 roadster seat belts



    

  Has anyone fitted inertia reels to the mounting point on the rear wheel arch - this is the forward one as pictured here http://www.paulhunt73.webspace.virginmedia.com/mgb-stuff/images/seatbelt67c.jpg, not the later one right at the back.



  Type used?  Any issues?  Or does it have to be statics on these?



  PaulH.



  __._,_.___

------------------------------------------------------------------------------
  Posted by: Kelvin Dodd <doddk at mossmotors.com> 
------------------------------------------------------------------------------

        Reply via web post  . Reply to sender  . Reply to group  . Start a New Topic  . Messages in this topic (3)  

  Visit Your Group 
   . Privacy . Unsubscribe . Terms of Use 

  .
   
   __,_._,___
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/mgs/attachments/20150408/5ba46a5c/attachment.html>