[Mgs] Aluminum bonding agent

[Max Heim]

I was thinking the same thing. Did you consider a rubber grommet?

--

Max Heim
'66 MGB GHN3L76149
If you're near Menlo Park, CA,
it's the primer red one with chrome wires


on 3/21/12 2:40 PM, Richard Ewald at richard.ewald at gmail.com wrote:

> JB weld leaps to mind, but I think you might have a huge problem trying to
> use anything to bond a filler neck to a tank.  The filler neck will act as
> a long lever, and any movement at the end of filler neck will quite likely
> crack any bonding agent at the lower end.
> Good luck
> Rick
> 
> On Wed, Mar 21, 2012 at 12:49 PM, davewillner <davewillner at pa.net> wrote:
> 
>> I need some advice on the availability of a very high strength aluminum
>> bonding agent, that can be used on a gas tank, to bond the filler neck
>> (long
>> story...). Does anyone know of an industrial bonding product that is
>> somewhat
>> easy to use that will make a strong, permanent bonding seal?  Thanks
>> 
>> Dave Willner
>> Stroudsburg PA
>> 59 TR3A
>> 70 MGB
>> 70 BSA 441 VS