[Mgs] Aluminum bonding agent

[Chad]

Or one of those pipe repair joints that is rubber and has hose clamps on
both ends.

Chad Cooper
'72 B Roadster
Allen, TX

-----Original Message-----
From: mgs-bounces at autox.team.net [mailto:mgs-bounces at autox.team.net] On
Behalf Of Max Heim
Sent: Wednesday, March 21, 2012 5:13 PM
To: MG List
Subject: Re: [Mgs] Aluminum bonding agent

I was thinking the same thing. Did you consider a rubber grommet?

--

Max Heim
'66 MGB GHN3L76149
If you're near Menlo Park, CA,
it's the primer red one with chrome wires


on 3/21/12 2:40 PM, Richard Ewald at richard.ewald at gmail.com wrote:

> JB weld leaps to mind, but I think you might have a huge problem 
> trying to use anything to bond a filler neck to a tank.  The filler 
> neck will act as a long lever, and any movement at the end of filler 
> neck will quite likely crack any bonding agent at the lower end.
> Good luck
> Rick
> 
> On Wed, Mar 21, 2012 at 12:49 PM, davewillner <davewillner at pa.net> wrote:
> 
>> I need some advice on the availability of a very high strength 
>> aluminum bonding agent, that can be used on a gas tank, to bond the 
>> filler neck (long story...). Does anyone know of an industrial 
>> bonding product that is somewhat easy to use that will make a strong, 
>> permanent bonding seal?  Thanks
>> 
>> Dave Willner
>> Stroudsburg PA
>> 59 TR3A
>> 70 MGB
>> 70 BSA 441 VS
_______________________________________________