[Mgs] B layshaft circlips

[Richard Ewald]

I like it!

There is a much easier way to remove the circlips. The only reason for
removing the clips is to replace the bearings, so we presume the old
bearings will not be re-used. Place a small punch against the clip half way
around from the tips, and give it a whack with a hammer to break the clip.



On Sat, Feb 6, 2010 at 9:29 PM, Barney Gaylord <barneymg at mgaguru.com> wrote:

> See here:
> http://mgaguru.com/mgtech/gearbox/gt203a.htm
>
> Look for the picture of the circlip 2/3 down the page.
>
>
> At 12:23 PM 2/6/2010 -0800, Richard Ewald wrote:
>
>> I'm helping a buddy rebuild a non syncro b gearbox with the type 1 laygear
>> bearings.
>>
>> How do you remove the circlips inside the ends of the laygear?
>> ....