[Mg-t] TD Engine Pull

[John Seim]

You can do that, but that requires the engine out of the car, to apply JB-Weld
to the oil thrower cap.
In the car, that cap is on the other side of the crankshaft.

John Seim
Irvine, CA

On Sep 12, 2013, at 7:27 PM, spook01 at comcast.net wrote:

> You can get good results with a process / procedure using JB Weld to build
the worn area up to match the Archimedes screw.
>
> Sent from my Verizon Wireless Phone
>
> ---------- Original Message ----------
> From: <wbeech at flash.net>
> To: <mg-t at autox.team.net>
> Subject: Re: [Mg-t] TD Engine Pull
> Date: Thu, 12 Sep 2013 15:33:49 -0500
>
> Finally getting around to the long-overdue task for replacing the rear main
> on the '52TD.  What is the consensus of the list as far as the best remedy
> for this repair/replacement?  I would rather not have to grind the crank to
> fit some aftermarket product.  Just going to do the seals and the top-end
is
> tight and there are no other real issues here.
>
> Also, as this is my first MGT engine job where is the best resource,
> on-line, to go to for soup-to-nuts guidance?
>
> Many thanks,
> Bill
> ______________________________________________
>
> Mg-t at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/mg-t/mgbob@juno.com
> ______________________________________________