[Healeys] BN2 Trans Dowel Bolts

[Michael MacLean]

Apparently the factory thought so.Mike M

Sent from AT&T Yahoo Mail on Android 
 
  On Sat, Mar 27, 2021 at 3:26 PM, Perry Small via Healeys<healeys at autox.team.net> wrote:   


More useless information. Using a regular 3/8 UNF bolt with a long enough shank could potentially allow the bell housing to hang 0.001 inch low on the engine back plate. 
The play in a new input shaft bearing will allow the tip of shaft (where it enters the bushing in the crank) to move, much more than 0.001. So is alignment really an issue with tolerances this small? 
P 

Sent from my iPhone_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75

Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/rrengineer.mike@att.net

  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20210328/05539bc1/attachment.htm>